Cisco Systems OL-27407-01 manual Installing the Power Cord Retention Lock, Ring Power cord lock

Chapter 2 Installing the Router

Installing the Cisco 810 ISR

After you install and properly ground the router, you can connect the power wiring, the LAN cables, and the cables for administrative access as required for your installation.

Installing the Power Cord Retention Lock

The Cisco 819 ISRs have a power cord retention mechanism as an accessory. It locks the power cord to the router so when a user accidentally pulls out the power cord, the power cord will not come out from the router. For the complete list of Cisco 819 ISRs that support power cord retention lock, see Table 1-7.

This section describes how to install the power cord retention lock.

Step 1 Pre-assemble the o-ring onto the barrel of the power cord as shown in Figure 2-30.

Figure 2-30 Pre-assemble the O-Ring onto the Barrel

1

2

3

285515

1

2

O-ring 3 Power cord lock

Power cord connector

Step 2 Place the power cord lock onto the power cord behind the connector overmold as shown in Figure 2-31. Slide the power cord lock forward so that it captures the overmold and is fully seated.

Figure 2-31 Place the Power Cord Lock onto the Power Cord

1

2

285516

1

O-ring

2

Power cord lock

	Cisco Integrated Services Router Hardware Installation Guide
2-34	OL-27407-01