Conair Portable Chillers Series 1Water-Cooled (W1) and Air-Cooled Models (A1) withTIC Control

Warm fluid from your process enters the chiller at the From Process valve and chilled fluid returns to the process equip- ment through the To Process valve.

1 Remove the shipping plastic pipe plug from the female connections on the back of the portable chiller.

2 Make sure the male pipe threads are clean and new.

3 Wrap threads with Mylar or Teflon tape.

4 Connect the From Process valve and tubing on the back of the chiller to the From Process tubing. Start by hand until the threads engage and then tighten with a pipe wrench. Tighten only enough to prevent leaks; do not over-tighten!

MAKING

PROCESS

PLUMBING

CONNECTIONS

5

Connect the To Process valve and tubing on

the back of the chiller to the return tubing. Start by hand until the threads engage and then tighten with a pipe wrench. Tighten only enough to prevent leaks; do not over-tighten!

For the Water-cooled Chillers connect the water source for cooling to the Condenser Water inlet on the back of the chiller. Connect the Condenser Water outlet for returning water.

back view

Condenser

Water Outlet

(water-cooled only)

Condenser

Water Inlet

(water-cooled only)

From Process valve

To Process valve

UGH016/0500 Series 1 Portable Chillers, TIC Control INSTALLATION 3-5