Conair Portable Chillers Series 1Water-Cooled (W1) and Air-Cooled Models (A1) withTIC Control

The control allows you to change four settings:

●Temperature Setpoint

The temperature you want the To Process liquid

●Temperature Scale

Choose to display temperature in degrees Fahrenheit or Celsius.

●Auto Tune

Helps maintain the temperature setpoint without over- shooting.

●To Process Low Limit

Set when need to chill fluid below 40 °F (4 °C) and down to 20 °F (-7 °C). Set this limit when using glycol to chill.

All other settings are set at the factory. You should not change any other settings. If you accidentally change any other set- ting, refer to the control manual that you received with your chiller and see Control Settings, in the Appendix. If you have any problems or questions, call your Conair Service represen- tative.

CHANGING SETTINGS

The current To Process temperature displays on the screen when the chiller is turned on. As the temperature changes, the number on the display changes.

The setpoint temperature is the temperature you want the water to be exiting the chiller at the To Process valve.

CHANGING THE

SETPOINT

TEMPERATURE

To set the temperature setpoint:

1

Press Menu button once.

The display flashes SP, and the current setpoint temperature.

2 Press the Up/Down arrows

to raise and lower the setpoint temperature. Each time you press the arrow the temperature changes one unit. Stop when you reach the tem- perature you want.

3 Press the Mode/Enter button

to accept the new setpoint temperature. The dis- play returns to the actual process temperature.

To return to the To Process Temperature screen from any other screen, press and hold the button for at least 5 seconds until the temperature displays.

UGH016/0500 Series 1 Portable Chillers, TIC Control OPERATION 4-5