From this
menu:
Honor Init
Parallel
Mode 2
MAC Binary
PS
You can:
to Fastbytes (if computer supports Fastbytes), or receive information at a normal transmission rate if the printer is set to Standard.
Standard
Fastbytes*
Determine whether the printer honors hardware initialization requests from the computer. The computer requests initialization by activating the INIT signal on the parallel interface.
Many personal computers activate the INIT signal each time the computer is turned on and off.
On
Off*
Determine whether the parallel port data is sampled on the leading (on) or trailing (off) edge of the strobe.
Off
On*
NOTE: This menu appears only if supported by the parallel port.
Configure the printer to process Macintosh binary PostScript emulation print jobs.
Off
On
Auto*
Parallel With |
| Configure the parallel port ENA address, Netmask, and Gateway settings. |
ENA |
| 4 field IP address (0.0.0.0*) |
|
| |
ENA | NOTE: These settings are shown only when ENA is attached through the | |
Address | ||
ENA |
| parallel port. |
Netmask |
|
|
ENA |
|
|
Gateway |
|
|
|
|
|
* Factory default setting
Settings
Mode
Mode Main Menu
Settings
General Settings
Setup Menu
