Dell 720H2C appendix

1.Follow the procedures in Before You Begin.

2.Remove the computer cover (see Removing the Computer Cover).

3.If present, press the tab on the card retention device that lays over the installed cards and rotate it upwards to gain full access to the card.

4.Gently securing both graphics cards with one hand, remove the graphics card bridge (if present) with your other hand by pulling it up and away from the computer. Set it aside.

1 graphics card bridge 2 power connectors (2) 3 dual-PCI Express graphics cards

5.Disconnect any cables connected to the card.

6.Press down the tab on the top of the card retainer at the appropriate card slot and pivot the card retainer back through the chassis wall.

1 release tab 2 card retainer 3 alignment guide

4fan bracket

7.Press the release tab (if present) on the system board connector as you grasp the card by its top corners, and then ease the card out of the connector.

NOTE: If the card is full length, press the release tab on the end of the alignment guides on the fan bracket.