3. Remove the drive panel (see Removing the Drive Panel).
4. Remove the existing media card reader, if applicable (see Removing a Media Card Reader).
5. If no screws are attached to the Media Card Reader, check the inside of the drive panel for shoulder screws. If screws are present, attach the screws to
the new card reader.
6. Slide the Media Card Reader into the drive bay until it clicks into place.
7. Attach the power and data cables to the back of the Media Card Reader.
8. Check all cable connections and fold cables out of the way to avoid blocking airflow between the fan and cooling vents.
9. Replace the drive panel (see Replacing the Drive Panel).
10. Replace the computer cover (see Replacing the Computer Cover).
11. Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
12. Enter system setup (see Entering System Setup) and select the appropriate USB for FlexBay option.
Optical Drive
1
media card reader
2
shoulder screws (4)
1
drive release latch
2
media card reader
NOTICE: To connect a network cable, first plug the cable in to the network port or device and then plug it in to the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.