Configuring iDRAC Quick Sync

Using iDRAC Web interface or RACADM, you can configure iDRAC Quick Sync feature to allow access to the mobile device:

Read-write access – Allows you to configure the basic iDRAC settings.

Read-only access – Allows you to view inventory and monitoring information.

Disabled access – Does not allow you to view information and configure settings.

Enables you to specify a time after which the Quick Sync mode is turned off.

You must have Server Control privilege to configure the settings. A server reboot is not required for the settings to take effect.

An entry is logged to the Lifecycle Controller log when the configuration is modified.

Configuring iDRAC Quick Sync Settings Using Web Interface

To configure iDRAC Quick Sync:

1.In the iDRAC Web interface, go to Overview Hardware Front Panel.

2.In the iDRAC Quick Sync section, from the Access drop-down menu, select one of the following to provide access to the Andriod mobile device:

Read-write

Read-only

Disabled

3.Enable the Timer.

4.Specify the Timeout value.

For more information about the fields, see the iDRAC Online Help.

5.Click Apply to apply the settings.

Configuring iDRAC Quick Sync Settings Using RACADM

To configure the iDRAC Quick Sync feature, use the racadm objects in the System.QuickSync group. For more information, see the iDRAC RACADM Command Line Reference Guide available at dell.com/ esmmanuals.

Configuring iDRAC Quick Sync Settings Using iDRAC Settings Utility

To configure iDRAC Quick Sync:

1.In the iDRAC Settings Utility, go to Front Panel Security. The iDRAC Settings Front Panel Security page is displayed.

2.In the iDRAC Quick Sync section:

Specify the access level.

Enable Timeout.

Specify the User Defined Timeout Limit (15 seconds to 3600 seconds).

For more information about the fields, see the iDRAC Online Help.

3.Click Back, click Finish, and then click Yes.

303

Page 303
Image 303
Dell iDRAC8 manual Configuring iDRAC Quick Sync Settings Using Web Interface