Dell iDRAC8 Object value modified, Successfully, Error RAC947 Invalid, Object value specified

Object	Description	Usage	Example
			The output is:
			Object value modified
			successfully.
			If a system does not support a
			particular air exhaust temperature
			limit, then when you run the
			following command:
			racadm set
			system.thermalsettings.AirE
			xhaustTemp 0
			The following error message is
			displayed:
			ERROR: RAC947: Invalid
			object value specified.
			Make sure to specify the value
			depending on the type of object.
			For more information, see RACADM
			help.
			To set the limit to the default value:
			racadm set
			system.thermalsettings.AirE
			xhaustTemp 255
FanSpeedHig	• Getting this variable reads	Values from 0-100	racadm get
hOffsetVal	the fan speed offset value		system.thermalsettings
	in %PWM for High Fan		FanSpeedHighOffsetVal
	Speed Offset setting.		This returns a value such as “66”.
	• This value depends on
			This means that when you use the
	the system.
			following command, it applies a fan
	• Use FanSpeedOffset
			speed offset of High (66% PWM)
	object to set this value		over the baseline fan speed
	using index value 1.
			racadm set
			system.thermalsettings
			FanSpeedOffset 1

FanSpeedLow OffsetVal

•Getting this variable reads Values from 0-100 the fan speed offset value

in %PWM for Low Fan Speed Offset setting.

•This value depends on the system.

•Use FanSpeedOffset object to set this value using index value 0.

racadm get system.thermalsettings FanSpeedLowOffsetVal

This returns a value such as “23”. This means that when you use the following command, it applies a fan speed offset of Low (23% PWM) over baseline fan speed

racadm set system.thermalsettings FanSpeedOffset 0

57