632 802.1x Commands
Example
The following example sets the time for the retransmission of an EAP-request
frame to the client to 3600 seconds.
console(config-if-1/g1)# dot1x timeout supp-timeout
3600
dot1x timeout tx-period
Use the dot1x timeout tx-period command in Interface Configuration mode
to set the number of seconds that the switch waits for a response to an
Extensible Authentication Protocol (EAP)-request/identity frame from the
client before resending the request. To return to the default setting, use the
no form of this command.
Syntax
dot1x timeout tx-period
seconds
no dot1x timeout tx-period
•
seconds
—
Time in seconds that the switch should wait for a response to
an EAP-request/identity frame from the client before resending the
request.
(Range: 1–65535)
Default Configuration
The period of time is set to 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Change the default value of this command only to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.