Dell initTtl, interval, maxFail, maxTtl

1328 System Management Commands
•You can enter traceroute to without specifying the IP address and
hostname, and specify values for the traceroute parameters.
Syntax
traceroute [ ip | ipv6 ] ipaddress | hostname [ initTtl initTtl ] [ maxTtl
maxTtl ] [ maxFail maxFail ] [ interval interval ] [ count count ] [ port port ]
[ size
size ]
• ipaddress — Valid IP address of the destination host.
•
hostname — Hostname of the destination host (Range: 1–158 characters).
•
initTtl — The initial time-to-live (TTL); the maximum number of router
hops between the local and remote system (Range: 0–255).
•
maxTtl — The largest TTL value that can be used (Range:1–255).
•
maxFail — Terminate the traceroute after failing to receive a response for
this number of consecutive probes (Range: 0–255).
•
interval — The timeout period. If a response is not received within this
period of time, then traceroute considers that probe a failure (printing *)
and sends the next probe. If traceroute does receive a response to a probe,
then it sends the next probe immediately. (Range: 1–60 seconds).
•
count — The number of probes to be sent at each TTL level
(Range:1–10).
•
port — The destination UDP port of the probe. This should be an unused
port on the remote destination system (Range: 1–65535).
•
size — The size, in bytes, of the payload of the Echo Requests sent
(Range: 0–65507 bytes).
Default Configuration
The default count is 3 probes.
The default interval is 3 seconds.
The default size is 0 data bytes.
The default port is 33434.
The default initTtl is 1 hop.
The default maxTtl is 30 hops.
The default maxFail is 5 probes.