Command Groups 113
ipv6 ospf mtu-ignore Disables OSPF maximum transmission unit
(MTU) mismatch detection.
IC
ipv6 ospf network Changes the default OSPF network type for the
interface.
IC
ipv6 ospf priority Sets the OSPF priority for the specified router
interface.
IC
ipv6 ospf retransmit-
interval
Sets the OSPF retransmit interval for the
specified interface.
IC
ipv6 ospf transmit-delay Sets the OSPF Transmit Delay for the specified
interface.
IC
ipv6 router ospf Enters Router OSPFv3 Configuration mode. GC
maximum-paths Sets the number of paths that OSPF can report
for a given destination.
ROSV3
passive-interface Sets the interface or tunnel as passive. IC
passive-interface default Enables the global passive mode by default for all
interfaces.
ROSV3
redistribute Configures the OSPFv3 protocol to allow
redistribution of routes from the specified source
protocol/routers.
ROSV3
router-id Sets a 4-digit dotted-decimal number uniquely
identifying the Router OSPF ID.
ROSV3
show ipv6 ospf Displays information relevant to the OSPF
router.
PE
show ipv6 ospf abr Displays the internal OSPFv3 routes to reach
Area Border Routers (ABR).
PE
show ipv6 ospf area Displays information about the area. PE
show ipv6 ospf asbr Displays the internal OSPFv3 routes to reach
Autonomous System Boundary Routes (ASBR).
PE
show ipv6 ospf database Displays information about the link state
database when OSPFv3 is enabled.
PE
show ipv6 ospf database
database-summary
Displays the number of each type of LSA in the
database and the total number of LSAs in the
database.
PE
Command Description Mode*