OSPFv3 Commands 947
Syntax
ipv6 ospf areaid
areaid
no ipv6 ospf areaid
areaid
•
areaid
— Is a 32-bit integer, formatted as a 4-digit dotted-decimal number
or a decimal value. It uniquely identifies the area to which the interface
connects. Assigning an area id which does not exist on an interface causes
the area to be created with default values. (Range: 0-4294967295).
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example defines the OSPF area to which VLAN 15 belongs.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf areaid 100
ipv6 ospf cost
Use the ipv6 ospf cost command in Interface Configuration mode to
configure the cost on an OSPF interface.
Syntax
ipv6 ospf cost
cost
no ipv6 ospf cost
•
cost
— Cost for OSPF interface. (Range: 1-65535)
Default Configuration
10 is the default value of
cost
.