1324 System Management Commands
•
value
— The priority of one backup switch over another. (Range: 0–12)
Default Configuration
The switch priority defaults to the hardware management preference value of
1.
Command Mode
Global Configuration mode
User Guidelines
Switches that do not have the hardware capability to become the
Management Switch are not eligible for management.
Once the priority of a switch has been configured, it cannot be reset to the
default. Switch priority is not affected by the "clear config" command.
Example
The following example displays how to configure switch number “1” to have a
priority of “2” for becoming the Management Switch.
console(config)#switch 1 priority 2
switch renumber
Use the switch renumber command in Global Configuration mode to change
the identifier for a switch in the stack. Upon execution, the switch is
configured with the configuration information for the new switch, if any is
available. The old switch configuration information is retained; however, the
old switch will be
operationally unplugged
.
Syntax
switch
oldunit
renumber
newunit
•
oldunit
— The current switch identifier. (Range: 1–12)
•
newunit
— The updated value of the switch identifier. (Range: 1–12)
Command Mode
Global Configuration mode