Dell snmp-server community

1230 SNMP Commands
console#show trapflags ospf
OSPF Traps:
errors: all..............................Disabled
authentication failure...........Enabled
bad packet.......................Enabled
config error.....................Enabled
virt authentication failure .....Disabled
virt bad packet..................Disabled
virt config error................Disabled
if-rx: if-rx-packet.....................Disabled
lsa: lsa-maxage.......................Disabled
lsa-originate....................Disabled
overflow: lsdb-overflow....................Enabled
lsdb-approaching-overflow........Enabled
retransmit: packets..........................Disabled
virt-packets.....................Disabled
rtb: rtb-entry-info...................Disabled
state-change: all..............................Disabled
if state change..................Enabled
neighbor state change............Enabled
virtif state change..............Disabled
virtneighbor state change........Disabled
snmp-server community
Use the snmp-server community command in Global Configuration mode to
set up the community access string to permit access to the SNMP protocol.
To remove the specified community string, use the no form of this command.
This Command places the user in SNMP-Community-Configuration mode.