944 OSPFv3 Commands
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables administrative mode of OSPF in the router
(active).
console(config)#ipv6 router ospf
console(config-rtr)#enable
exit-overflow-interval
Use the exit-overflow-interval command in Router OSPFv3 Configuration
mode to configure the exit overflow interval for OSPF. It describes the
number of seconds after entering Overflow state that a router will wait before
attempting to leave the Overflow State. This allows the router to originate
non-default AS-external-LSAs again. When set to 0, the router will not leave
Overflow State until restarted.
Syntax
exit-overflow-interval
seconds
no exit-overflow-interval
•
seconds
— Exit overflow interval for OSPF (Range: 0-2147483647)
Default Configuration
0 is the default value for
seconds
.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.