System Management Commands 1323
standby
Use the standby command to configure the standby in the stack. This unit
comes up as the master when the stack failover occurs. Use the no form of
this command to reset to default, in which case, FASTPATH automatically
selects a standby from the existing stack units if there no preconfiguration.
Syntax
standby
unit
•
unit
— Valid unit number in the stack. (Range: 1–12 maximum. The range
is limited to the number of units available on the stack.)
Default Configuration
This command has no default configuration.
Command Mode
Stack Global Configuration
User Guidelines
No specific guidelines.
Examples
console(config)#stack
console(config-stack)#standby 2
switch priority
Use the switch priority command in Global Configuration mode to configure
the ability of the switch to become the Management Switch. The switch with
the highest priority value is chosen to become the Management Switch if the
active Management Switch fails.
Syntax
switch
unit
priority
value
•
unit
— The switch identifier. (Range: 1–12)