Dell PP09L owner manual Display Latch, rubber display bumpers, display bezel

Display Latch

CAUTION: Before you begin this procedure, read the safety instructions at the front of this document (see page 11).

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the computer.

NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.

1Follow the procedures in "Before You Begin" (see page 103).

2Remove the display (see page 124).

3Remove the eight rubber display bumpers.

4Remove the two M2.5 x 6-mm shoulder screws and six M2.5 x 6-mm screws, and remove the display bezel.

M2.5 x 6-mm screws (6) rubber display bumpers

M2.5 x 6-mm shoulder screws (2) display bezel

Adding and Replacing Parts

127