Dell PP09L owner manual b Remove the module from the connector at a 45-degree angle

w w w . d e l l . c o m s u p p o r t . d e l l . c o m

106

NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory-module securing clips.

3If you are replacing a memory module, ground yourself and remove the existing module:

a Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.

b Remove the module from the connector at a 45-degree angle.

memory module

securing clips (2 per connector)

NOTICE: Ensure that memory modules are installed in both connectors and they are of the same capacity. Insert memory modules at a 45-degree angle to avoid damaging the connector.

4Ground yourself and install the new memory module:

NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.

aAlign the notch in the module edge connector with the tab in the connector slot.

bSlide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it.

Adding and Replacing Parts