Back to Contents Page

Drives

Dell Precision™ Workstations 450 and 650 User's Guide

Overview

Hard Drive

Floppy Drive

CD/DVD Drive

Overview

Your computer supports:

Three hard drives (Your computer supports IDE, Serial ATA, and SCSI.)

One floppy drive

Three CD or DVD drives (One bay may be used for additional hard drive using an add-in bay bracket.)

1floppy drive(s)

2CD/DVD drive(s)

3hard drive(s)

IDE Drive Addressing

When you connect two IDE devices to a single IDE interface cable and configure them for the cable select setting, the device attached to the last connector on the interface cable is the primary (master) or boot device (drive 0), and the device attached to the middle connector on the interface cable is the secondary (slave) device (drive 1). See the drive documentation in your upgrade kit for information on configuring devices for the cable select setting.

Since cable select is the default setting, any additional drives that are installed do not need to be set as a primary or secondary drive.

Your computer supports up to two IDE devices. Hard drives should be connected to the connector labeled "IDE1," and CD/DVD drives should be connected to the connector labeled "IDE2."

Connect serial ATA drives to the connectors labeled "SATA_0" or "SATA_1."

Connecting Drive Cables

When you install a drive, you connect two cables—a DC power cable and an interface cable—to the back of the drive.

Page 103
Image 103
Dell PRECISION WORKSTATION 450 manual Drives