w w w . d e l l . c o m s u p p o r t . d e l l . c o m

netstat

NOTE: To use this command, you must have Execute Diagnostic Commands permission.

Table A-19 describes the netstat subcommand.

Table A-19. netstat

Subcommand

Definition

 

 

netstat

Prints the contents of the routing table. If the optional interface number is provided,

 

then netstat prints additional information regarding the traffic across the interface,

 

buffer usage, and other network interface information.

 

 

Synopsis

racadm netstat [<network interface number>]

ping

NOTE: To use this command, you must have Execute Diagnostic Commands or

Configure DRAC 4 permission.

Table A-20 describes the ping subcommand.

Table A-20. ping

Subcommand

Definition

 

 

ping

Verifies that the destination IP address is reachable from the DRAC 4 with the

 

current routing-table contents. A destination IP address is required. An ICMP echo

 

packet is sent to the destination IP address based on the current routing-table contents.

 

 

Synopsis

racadm ping <ipaddress>

setniccfg/getniccfg

NOTE: To use the setniccfg command, you must have Configure DRAC 4 permission.

NOTE: To use the getniccfg command, you must have Log In To DRAC 4 permission.

Table A-21 describes the setniccfg and getniccfg subcommands.

164

racadm Subcommand Man Pages

Page 164
Image 164
Dell Remote Access Controller 4 Firmware Version 1.30 manual Netstat, Ping, Setniccfg/getniccfg, Racadm ping ipaddress