Dell Remote Access Controller 4 Firmware Version 1.30 Hardware Specifications, Power Requirements

Hardware Specifications

Power Requirements

Table 1-1 lists the power requirements for the DRAC 4.

Table 1-1. DRAC 4 Power Requirements

System Power

1.2A on +3.3 V AUX (maximum)

550 mA on +3.3 V main (maximum)

0 mA on+5V main (maximum)

Connectors

NOTE: Installation instructions for the DRAC 4 hardware can be found in the Installing a Remote Access Card document or the Installation and Troubleshooting Guide that comes with your system. Ensure that you connect the management cable and the local video monitor (if present) to the DRAC 4/P in PCI slot 4.

The DRAC 4 provides a dedicated 10/100 Mbps RJ-45 NIC and a connector for mounting the card to the system board. The DRAC 4/P also provides a video connector, and a 30-pin Management Connector.

DRAC 4 Ports

Table 1-2 identifies the ports used by the DRAC 4. This information is required when opening firewalls for remote access to a DRAC 4.

Table 1-2. DRAC 4 Port Numbers

DRAC 4 Port Number Used For

Ports on DRAC 4 listening for connection (server):

22Secure Shell (configurable)

23Telnet (configurable)

80HTTP (configurable)

161SNMP Agent (not configurable)

443HTTPS (configurable)

3668	Virtual Media server (configurable)
5869	Remote racadm spcmp server (not configurable)
5900	Console Redirection (configurable)

DRAC 4 Overview

23