Dell Remote Access Controller 4 Firmware Version 1.30 manual Setrac, Racadm setrac -h -o -T -d

Description

The gettracelog -icommand displays the number of entries in the DRAC 4 trace log. The gettracelog (without the -ioption) command reads entries.

The -moption displays 24 rows at a time, and queries for more (such as the UNIX more command).

Output

One line of output is displayed for each trace log entry.

setrac

Table A-32 describes the setrac subcommand.

Table A-32. setrac

Subcommand	Definition
setrac	Sets DRAC 4 parameters from the managed system. When used remotely,
	sets DRAC 4 parameters from the management station.

Synopsis

racadm setrac [-h -o -T -d]

Description

NOTE: The racadm setrac command cannot be used remotely.

The setrac command sets the managed system name, operating system name, or operating system type from the managed system to the DRAC 4. If options are not typed, all four parameters are set. The -doption allows the user to display the parameters only without actually writing them to the DRAC 4 firmware. Any combination of options, or no options, may be typed.

Input

Table A-33 describes the setrac subcommand options.

Table A-33. setrac Subcommand Options

Option	Description
-h	Gets the Hostname from the managed system and writes it to the DRAC 4. This
	parameter is available for viewing using the getsysinfo command, and under the object ID
	interface using config/getconfig as [ifcRacManagedNodeOs] ifcRacMnOsHostname.
-o	Gets the OS name from the managed system and writes it to the DRAC 4. This parameter
	is available for viewing under the object ID interface using config/getconfig as
	[ifcRacManagedNodeOs] ifcRacMnOsName.

racadm Subcommand Man Pages

173