Dell Remote Access Controller 4 Firmware Version 1.30 manual Options, 175

Options

NOTE: The -u and -f options are not supported for the serial/telnet console.

Table A-35 describes the sslcsrgen subcommand options.

Table A-35. sslcsrgen Subcommand Options

Option	Description
-g	Generates a new CSR.
-s	Returns the status of a CSR generation process (generation in progress, active, or none).
-u	Uploads the CSR to the filename specified by the -f option.
-f	Specifies the filename of the location, <filename>, where the CSR will be downloaded.

NOTE: If the -f option is not specified, the filename defaults to sslcsr in your current directory.

If options are not specified, the default is -g-u. The -g-uoptions (together) cannot be used with the -soption. The -foption must be used with the -uoption.

The sslcsrgen -ssubcommand returns one of the following status codes:

0x00000000 — CSR was generated successfully.

0x40040014 — CSR does not exist.

0x40040006 — CSR generation in progress.

0x40040009 — Key size is not supported.

The sslcsrgen -usubcommand downloads the CSR from the DRAC 4 by FTP. This command returns 0 when successful and returns a nonzero number when unsuccessful.

Restrictions

•The sslcsrgen command can only run on a system that has the managed system software installed.

•While generating a CSR, the local racadm interface on the host becomes unavailable. Use remote racadm or the racadm available on serial or telnet command lines instead.

Examples

racadm sslcsrgen -s

or

racadm sslcsrgen -g -u -f c:\csr\csrtest.txt

racadm Subcommand Man Pages

175