Dell YT583 manual Removing a Fifth Sata Hard Drive Optional, 239

14If the drive you just installed is the primary drive, insert bootable disc into drive A.

15Turn on the computer.

16Enter system setup, and update the appropriate Drive option (see "System Setup" on page 75).

17Exit system setup, and reboot the computer.

18Partition and logically format your drive before you proceed to the next step.

See the documentation for your operating system for instructions.

19Test the hard drive by running the Dell Diagnostics. See "Dell Diagnostics" on page 123.

20If the drive you just installed is the primary drive, install your operating system on the hard drive.

Removing a Fifth SATA Hard Drive (Optional)

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

1Follow the procedures in "Before You Begin" on page 139.

CAUTION: Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See your Product Information Guide for other important safety information.

CAUTION: The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the computer tipping over, potentially resulting in bodily injury or damage to the computer.

2Remove the computer cover (see "Removing the Computer Cover" on page 141).

3Remove the drive panel (see "Removing the Drive Panel" on page 246).

4Disconnect the power cable from the back of the hard drive.

Adding and Replacing Parts

239