Dell YT583 manual Installing a Media Card Reader, 261

bInstall a drive panel insert (see "Replacing a Drive-Panel Insert" on page 249).

9If you are installing another drive in the drive bay, see the appropriate installation instructions.

10Reinstall the drive panel (see "Replacing the Drive Panel" on page 249).

11Replace the computer cover (see "Replacing the Computer Cover" on page 145).

NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.

12Connect the computer and devices to electrical outlets, and turn them on.

Installing a Media Card Reader

1Follow the procedures in "Before You Begin" on page 139.

CAUTION: Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See your Product Information Guide for other important safety information.

CAUTION: The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the computer tipping over, potentially resulting in bodily injury or damage to the computer.

2Remove the computer cover (see "Removing the Computer Cover" on page 141).

3Remove the drive panel (see "Removing the Drive Panel" on page 246).

4If the 3.5-inch drive-panel insert is installed, remove it (see "Removing a Drive-Panel Insert" on page 247). Otherwise, ensure that the 3.5-inch drive panel plate is installed.

5If another device is installed in the drive bay, remove that device (see the appropriate device removal instructions).

6If no screws are attached to the Media Card Reader, check the inside of the drive panel for shoulder screws. Attach screws to the new card reader.

Adding and Replacing Parts

261