11Ensure that memory riser card 3 is above system-board connector DIMM_3 and memory riser card 4 is above system-board connector DIMM_4.

Align the notch on the bottom of each riser card with the crossbar in each system-board connector.

12Insert the riser cards into the connectors until both riser cards snap into position.

1

2

1 memory riser cards 1 and 2 2 memory riser cards 3 and 4

NOTE: If a memory-riser power cable is not plugged in, the system will not boot.

13Connect the power cables back into memory riser cards 3 and 4.

14Ensure that memory riser card 1 is above system-board connector DIMM_1 and memory riser card 2 is above system-board connector DIMM_2.

Align the notch on the bottom of each riser card with the crossbar in each system-board connector.

Adding and Replacing Parts

185

Page 185
Image 185
Dell YT583 manual 185