Dell YT583 manual Installing a Fifth Sata Hard Drive Optional, 242

12Replace the computer cover (see "Replacing the Computer Cover" on page 145).

NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.

13Connect the computer and devices to electrical outlets, and turn them on.

Installing a Fifth SATA Hard Drive (Optional)

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

NOTICE: In order to install a fifth SATA hard drive in one of the 5.25-inch drive bays, it must be installed in the provided hard-drive carrier.

1If you are installing a new drive, unpack the drive and prepare it for installation.

Check the documentation for the drive to verify that it is configured for your computer.

2Follow the procedures in "Before You Begin" on page 139.

CAUTION: Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See your Product Information Guide for other important safety information.

CAUTION: The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the computer tipping over, potentially resulting in bodily injury or damage to the computer.

3Remove the computer cover (see "Removing the Computer Cover" on page 141).

4Remove the drive panel (see "Removing the Drive Panel" on page 246).

5If you are installing a new drive, remove the drive-panel insert from a 5.25- inch drive bay (see "Removing a Drive-Panel Insert" on page 247).

If you already have a drive installed in the drive bay, remove the optical or hard drive. See the appropriate removal instructions.

242

Adding and Replacing Parts