10Ensure that memory riser card 3 is above system-board connector DIMM_3 and memory riser card 4 is above system-board connector DIMM_4.

Align the notch on the bottom of each riser card with the crossbar in each system-board connector.

11Insert the riser cards into the connectors until both riser cards snap into position.

NOTE: If a memory-riser power cable is not plugged in, the system will not boot.

1

2

3

1

power connectors

2 connector

3

securing clips (2)

 

12Connect the power cables to memory riser cards 3 and 4.

13Ensure that memory riser card 1 is above system-board connector DIMM_1 and memory riser card 2 is above system-board connector DIMM_2.

Align the notch on the bottom of each riser card with the crossbar in each system-board connector.

192

Adding and Replacing Parts

Page 192
Image 192
Dell YT583 manual 192