
7. Maintenance
This section describes the simple maintenance procedures you should follow to clean the filters and replace the lamp.
Cleaning or Replacing the Filter
The
CAUTION
•Turn off the projector, turn off the main power switch and unplug the projector before replacing the filter.
•Only clean the outside of the filter cover with a vacuum cleaner.
•Do not attempt to operate the projector without the filter cover.
To clean the air-filter:
Vacuum the filter-through the filter cover.
T
EC
SEL
UP
NDOW
IGHTR |
|
SHIFT | LEFT |
LENS |
Filter
To reset the filter usage time, from the menu, select [Reset] → [Clear Filter Hours]. (→ page 107 for resetting the filter usage time)
To replace the filter (sponge):
CAUTION
•Replace both filters at the same time.
•Before replacing the filters, remove dust and dirt from the projector cabinet.
•The projector contains
•Do not wash the filter with water. Water will damage the filter membrane.
•Reattach the filter cover correctly. Failure to do so may cause projector malfunction.
Preparation: Replace the lamp before replacing the filters.
NOTE: When you replace the lamp, it is also wise to replace the filter. The filter comes in the same package with your replacement lamp.
1. Pull to remove the filter cover.