Dukane 8808 Appendix, Troubleshooting, Indicator Messages, Power Indicator, The main power is off

9. Appendix

Troubleshooting

This section helps you resolve problems you may encounter while setting up or using the projector.

Indicator Messages

Power Indicator

	Indicator Condition		Projector Condition	Note
	Off		The main power is off	–
Blinking light	Green	0.5 sec On,	The projector is getting ready to turn on.	Wait for a moment.
		0.5 sec Off
		2.5 sec On,	Off Timer or Program Timer (Off Time) is	–
		0.5 sec Off	activated.
	Orange	0.5 sec On,	The projector is cooling down.	Wait for a moment.
		0.5 sec Off
		2.5 sec On,	Program Timer (On Time) is activated.	–
		0.5 sec Off
Steady light	Green		The projector is turned on.	–
	Orange		The projector is in Standby.	–
Status Indicator
	Indicator Condition		Projector Condition	Note
	Off		Normal	–
Blinking light	Red	1 cycle (0.5 sec On,	Lamp cover error	Reattach the lamp cover correctly.
		2.5 sec Off)		(→ page 112)
		2 cycle (0.5 sec On,	Temperature error	The projector is overheated. Move
		0.5 sec Of)		the projector to a cooler location.
		3 cycle (0.5 sec On,	Power error	Power unit will not work correctly.
		0.5 sec Off)
		4 cycle (0.5 sec On,	Fan error	Fans will not work correctly.
		0.5 sec Off)
		6 cycle (0.5 sec On,	Lamp error	Lamp fails to light. Wait a full
		0.5 sec Off)		minute and then turn on again.
	Green		Re-firing the lamp	The projector is re-firing.
	Orange	1 cycle (0.5 sec On,	Network conflict	Both the built-in LAN and the wire-
		2.5 sec Off)		less LAN cannot be connected to
				the same network at the same time.
				To use both built-in LAN and wire-
				less LAN at the same time, connect
				them to different networks.
				(→ page 90, 91)
Steady light	Orange		Control Panel Lock is on	You have pressed cabinet button
				when Control Panel Lock is on.
				(→ page 82)
	Green		The projector is in Standby.	–
Lamp Indicator
	Indicator Condition		Projector Condition	Note
	Off		Normal	–
Blinking light	Red		Lamp has reached its end of life. Lamp	Replace the lamp.
			replacement message will be displayed.	(→ page 110)
Steady light	Red		Lamp has been used beyond its limit. The	Replace the lamp.
			projector will not turn on until the lamp is	(→ page 110)
			replaced.
	Green		Lamp is in Eco mode	–

117