Emerson ATCA-S201 manual Network configuration, IP host

RTM-ATCA-SXXX Overview

4Network configuration

Configuration Step:

1	2	3	4	5	6
RS232	Ethernet	RAID	Logical Volume	iSCSI	NFS / SMB
Console Setup	Comm. Setup	LUN Setup	Setup	Device Setup	Share Setup

This chapter explains how to configure the IP ports for external host access. The ATCA-S201

offers 5 Ethernet ports within the ATCA environment, as follows:

∙Two 10Gb XAUI fabric ports (zone-2)

∙Two 1Gb base ports (zone-2)

∙One 1Gb management port (zone-3)

AMC disk		Physical	Logical	iSCSI & NAS
modules		disks	groups
			&		2
Site: B1			volumes	iSCSI
	HW RAID	sda	vga	LUNs
Site: B2					Zone-2 Fabric
						IP network
Site: B3	1:1 mapping (JBOD)	sdb		NFS	Zone-2 Base	IP host
				share points	Zone-3 RTM
Site: B4	1:1 mapping (JBOD)		vgz
		sdc
				CIFS
				share points

Storage is ultimately served out over these IP ports using iSCSI, NFS and SMB protocols. Administrators may individually enable and configure these ports. Configuration can be done using the serial console port, Telnet or via HTML. This chapter assumes the reader is familiar with internet protocols and TCP/IP networking.

Note: This chapter provides how-to-use details for the secure web configuration tool. Optionally, the user may perform configuration by establishing a login session from a secure shell (ssh) window, and running the command line utility (CLI). Refer to section 3.4.5, titled Command line configuration tool for more information.

6806800H62B ATCA‐S201 Installation and Use Guide 34