RTM-ATCA-SXXX Overview

CLI command syntax

Table 19 CLI command syntax, set network property: assign NTP server

 

atca_blade set_network Y 10+ <server1> … [server5]+

Convention:

<server1>

Enter one to five NTP servers, specified as Dotted decimal or domain addresses

<server5> (time.nist.gov)

4.6.8Network time protocol - NTP (On/Off)

<Read/Write> Users may enable NTP protocol service to synchronize the ATCA- S201’s clocks with a known good reference time source.

4.6.9Ethernet network port identification

The ATCA-S201 provides multiple Ethernet interfaces that host blades may use to access storage. Whether using the CLI or web based configuration tools, these ports are identified with the Linux resource labels shown in the table below

Table 20 Ethernet ports for chassis communications (base/fabric)

Linux interface identifier

Port Description

/dev/eth0

10/100/1000 — Base 0 (Zone -2)

 

 

/dev/eth1

10/100/1000 — Base 1 (Zone -2)

 

 

/dev/eth2

10/100/1000 — Management (RTM, Rear I/O management

 

port)

 

 

/dev/eth3

10G — Fabric 0 (Zone-2 XAUI )

 

 

/dev/eth4

10G — Fabric 1 (Zone-2 XAUI )

 

 

The webtool provides a table for each Ethernet resource. Users may enter new settings for any field, and click the submit button located at the top of the screen to apply the settings.

Management[eth#] Network configuration

 

IP Address

Network Mask

Broadcast

Gateway

MTU Size

MAC Address

Active Settings

192.168.200.32

255.255.255.0

192.168.200.255

192.168.200.1

1500

00:11:0D:xx:xx:xx

 

 

 

 

 

 

 

New Settings

dhcp

0.0.0.0

0.0.0.0

0.0.0.0

1500

DHCP Enable

6806800H62B ATCA‐S201 Installation and Use Guide

42

Page 52
Image 52
Emerson ATCA-S201 manual Network time protocol NTP On/Off, Ethernet network port identification