Emerson ATCA-S201 Command line configuration tool, Change IP address of any Ethernet resource

RTM-ATCA-SXXX Overview

3.5Command line configuration tool

This tool is available from either the RS232 console or a linux secure shell connection. After successful login, the user may run an executable file “atca_blade” located in the /web/cgi-bindirectory. The tool provides the user with a simple menu interface, to perform interactive parameter modifications. A sample session is shown below.

#ssh 192.168.1.xxx -l root root@192.168.1.xxx's password: root

Last login: Tue Nov 20 17:34:30 2007 from 192.168.1.xxx

#cd /web/cgi-bin /web/cgi-bin# atca_blade

3.5.1Change IP address of any Ethernet resource

The ATCA-S201 provides multiple Ethernet interfaces that host blades may use for initial setup and configuration. These ports are identified with the Linux resource labels shown in the table below

Table 7 Ethernet ports for chassis communications (base/fabric)

Linux interface identifier	description
/dev/eth0	Chassis Base port 0, 1Gb link
/dev/eth1	Chassis Base port 1, 1Gb link
/dev/eth2	RTM, Rear I/O management port.
/dev/eth3	Chassis fabric port 0, 10Gb XAUI link
/dev/eth4	Chassis fabric port 1, 10Gb XAUI link

Perform manual Interactive changes

After invoking the command line tool (atca_blade), the user can modify any of the parameters within the functional groupings listed above. For example, select the “2. Network Settings” group. The configuration tool will display the entire list parameters in the group, along with their present values.

Main Page for CLI Interface

1.	IPMI Settings (get_status)
2.	Network Settings (set_network)
3.	Hardware Raid Configuration (set_raid)
4.	Logical Volume Mangager LVM2 Configuration (set_lvm2)
5.	Manage Shares (set_shares)
6.	smb Configuration (set_smb)
7.	nfs Configuration (set_nfs)
8.	iSCSI Configuration (set_iscsi)
9.	Web gui enable (set_gui)
10.	Allow Web and CLI at the same time (set_useroverride)
0.	Exit
Enter choice [1-10], 0 to exit: [0]: 2
-------------- System Identification and TimeZone Active Settings -----
Hostname=[BladeHost]:
DomainName=[Emerson.com]
6806800H62B ATCA‐S201 Installation and Use Guide		26