Emerson ATCA-S201 manual Zone 2 Connectors, 6806800H62B ATCA‐S201 Installation and Use Guide 111

ATCA Receptacle view

1	2	3	4
5	6	7	8
9	10 11		12
13	14 15		16
17	18	19	20
21	22	23	24

25 26

28 27 29

30 31

33 32 34

RTM-ATCA-SXXX Overview

ATCA PCB

			Figure 32 Zone 1 J10 Connector Port Pin Location Diagram
			Table 46 Connector J10, Zone-1 Pin Assignments
	Pin#	Signal		Pin#	Signal	Pin#	Signal
	1	NC		10	PP_HA5	19	NC
2		NC		11	PP_HA6	20	NC
	3	NC		12	PP_HA7	21	NC
4		NC		13	PP_IPMB_SCL_A	22	NC
5		PP_HA0		14	PP_IPMB_SDA_A	23	NC
6		PP_HA1		15	PP_IPMB_SCL_B	24	NC
7		PP_HA2		16	PP_IPMB_SDA_B	25	Shelf Ground
	8	PP_HA3
				17	NC	26	Logic Ground
9		PP_HA4		18	NC	27	PPENABLE_B

Pin# Signal

28VRTN_A

29VRTN_B

30N48V_A

31N48V_B

32PPENABLE_A

33N48V_A

34N48V_B

10.2.3 Zone 2 Connectors

The ATCA-S201 provides Ethernet fabric and base ports on the Zone-2 connector designated as J23 on the ATCA board. This connector is implemented with a 4-pin per column type available from Tyco electronics (http://www.tycoelectronics.com), part number 6469081-1.

Note: The connector pin-outs are presented from the point of view of ATCA blade, such that:

‘TX’ refers to ATCA as the signal source, and chassis as the signal receiver. ‘RX’ refers to ATCA blade as signal receiver, and chassis as the signal source.

6806800H62B ATCA‐S201 Installation and Use Guide 111