Emerson ATCA-S201 manual Create a logical Volume Group /dev/vga

	RTM-ATCA-SXXX Overview
Table 21 HTML tool, Emerson ATCA-S201 Physical Disk (configuration screen)
Parameter	Description
Device Name	Linux SCSI device name, from ATCA-S201 management perspective
State	Online: indicates the device is active and ready for I/O
	Offline:
Type	Raw: indicates the device was not formatted by the ATCA-S201
	file: indicates the device was formatted by the ATCA-S201
Parent	Identifies the volume that claims ownership to a disk. ‘Unknown’
	indicates disk has no known volume ownership.
Host/Bus/Target/LUN	Identifies the SCSI parameters used to address the physical device
Vendor/model/Rev	Identifies the vendor and revision of the disk device. If vendor =
	LSILogic, this physical device is a RAID volume managed by the ATCA-
	S201 resources.

6.3Create a logical Volume Group (/dev/vga)

A volume group must contain at least one physical disk member. The figure below outlines the steps that will be taken to create volume groups and logical device/disk volumes.

				55% spare	15% nfs	40% iSCSI	20% nfs
							20% cifs
		Emerson ATCA-S201
‐				Logical disk
	+
			iSCSI
	+		nfs	(example: /dev/vga/lva0)	30% iSCSI	20% iSCSI
	+		smb
	+		Shares
			LVM2	Volume group
	‐
			 LVM2 Configuration	(example: /dev/vga)
	‐		MD RAID
			 Configuration
	‐		Hardware RAID
			 Configuration	RAID
	‐		Physical Disks

/dev/sda

 /dev/sdb
 /dev/sdc	Physical disks
 /dev/sde
 /dev/sdd
 /dev/sdf	(example: /dev/sda)

/dev/sdg

+ Maintenance

Figure 22 HTML tool, Main navigation side-bar, LVM2->Configuration

Logical volumes are comprised of one or more physical disk members. Using the HTML configuration tool, the user may view the available set of physical disks and assign them to volume groups.

Emerson ATCA-S201  LVM2  LVM2 Configuration

The screen shows physical disks which are available for a new volume group definition.

6806800H62B ATCA‐S201 Installation and Use Guide 70