Emerson ATCA-S201 manual Enable online/offline, Dhcp, IP address, Network Subnet mask

RTM-ATCA-SXXX Overview

CLI command syntax

Table 21 CLI command syntax, set network property: Ethernet port configuration

Convention:

<portcode>

<enable>

<dhcp>

Remaining inputs

atca_blade set_network Y <portcode+> <enable> <dhcp> <ipaddr> <netmask> <broadcast> <gateway> <MAC> <MTU> +

Use portcode 16+ to modify eth0 Use portcode 24+ to modify eth1 Use portcode 32+ to modify eth2 Use portcode 40+ to modify eth3 Use portcode 48+ to modify eth4 Use portcode 52+ to modify VLAN 01

Value 0 disables the port, value 1 enables the port. 01

Value 0 disables dhcp, value 1 enables the dhcp. When enabled, other network input fields are ignored. (ipaddr, netmask etc.)

ipaddr, netmask input formats etc. are defined in the sections below

4.6.10 Enable (online/offline)

<Read/Write> The user may set a port online or offline with this menu box. When enabled the port in online, and will terminate IP traffic. When the port is disabled, IP packets are not processed.

4.6.11 DHCP

<Read/Write> The user may configure any port for Dynamic Host Configuration Protocol (DHCP). If DHCP is enabled, the port will search for a DHCP server to automatically set the IP address, subnet mask, default gateway address.

4.6.12 IP address

<Read/Write> The user may manually assign the IP address of a port, if DHCP is NOT enabled. The address must be entered using dotted decimal notation. (e.g. 192.168.1.211)

4.6.13 Network (Subnet) mask

<Read/Write> The user may manually assign the subnet mask of a port, if DHCP is NOT enabled. The subnet mask must be entered using dotted decimal notation. (e.g. 255.255.255.0)

6806800H62B ATCA‐S201 Installation and Use Guide 43