Emerson ATCA-S201 Auto logout inactivity period, Single session management override, Html home

RTM-ATCA-SXXX Overview

4.3.1Auto logout inactivity period

The system will automatically terminate (logout) a remote user after 10 minutes of in-activity. Optionally, the user can create this file to set an alternate inactivity threshold value (expressed in seconds):

# echo 60 >/etc/max_inactivity

Note: In absence of this file, the value is set to 600 seconds.

4.3.1.1Forced user logout

A local user may immediately terminate an active management session by deleting the following file:

# rm /tmp/curruser

The above command will require the remote user to re-login, or allow the administrator to launch the atca_blade CLI tool locally.

4.3.2Single session management override

Blade management is restricted to one admin user at a time, thus preventing blade configuration conflicts from multiple remote locations. Moreover, a user may not simultaneously operate the atca_blade CLI tool with the web GUI configuration tool.

Users may optionally override this protection mechanism using either of the following mechanisms:

Web GUI command

Refer to page 55, Table 24 ATCA status indication, for the instructions to enable this override “Allow GUI and CLI”.

CLI command syntax

Table 11 CLI command syntax, single session management override

Convention

< enable>

atca_blade set_useroverride <enable> +

01

Value 0 disables the GUI, value 1 enables the GUI.

4.4HTML home page

Once logged in, the user will see the start-up screen shown in the figure below. Left click the folder panel to expand the menu configuration tools.

+ Emerson ATCA-S201

6806800H62B ATCA‐S201 Installation and Use Guide 36