❑The binding area should be flat and have no creases.
❑The sprocket holes of all sheets in the form should be aligned
properly.
❑The binding position should be outside the printable area.
Dimensions and See page A-4–5 for single-sheet multi-part forms
Printable area See page A-6–7 for continuous multi-part forms
Labels❑Labels should be securely attached to the backing sheet and the
label surface must be flat.
❑The labels should not peel off their backing sheet under the
conditions below.
❑When using labels whose backing sheet is entirely covered, make
sure the cuts around the edges of the labels are perforated.
❑When using labels whose backing sheet is not covered with the
label material, see the illustration below and do not set the paper
thickness lever to the AUTO position, set it manually.
label
27 mm
wrapping drum radius 27 mm
wrapping angle 180°
wrapping time 24 hours
ambient temperature 40°C
ambient humidity 30%
label
several uncut areas
on each side
label sheet
backing sheet Me-086
corner radius is
2 to 3 mm
label
backing sheet
label Me-087
LMaple Rev.D
A5 size Appendix A
06/17/97 pass 0
A-8 Specifications