FARGO electronic II manual Loading the Overlaminate into the Printer

C. Loading the Overlaminate into the Printer

CAUTION!

!

1.Remove the overlaminate from its packaging.

2.The supply end of the overlaminate roll is the side containing the fresh, unused portion of the overlaminate. The take-up end is the other side.

3.Open the top-left cover of the printer by pressing its Cover Release Button. Allow the cover to swing up and open.

4.With the cover open, place the supply end of the overlaminate roll in between the two black Lamination Drive Hubs located just to the left of the printerÕs card flipping mechanism. Make certain that the overlaminate material is fed from underneath the roll. (Hint: The Lamination Drive Hub nearest you, as you are looking into the printer from the front, is spring loaded. Use the end of the roll’s supply core to push in this hub when inserting the overlaminate roll.)

The loading process for both the thermal transfer film and the PolyGuard overlaminate material is the same. Refer to the following steps to load either type of overlaminate into the Printer.

DO NOT TOUCH THE METAL LAMINATION SHIELD OR THE LAMINATION ROLLER WHEN LOADING OVERLAMINATE. YOU WILL BURN YOURSELF!

Supply

Take-up

Take-up	Supply	Card Flipping
Lamination	Lamination
Drive Hubs	Drive Hubs	Mechanism

23