FARGO electronic II manual Identifying the Parts

	on/cancel	on-line	clean/ribbon
	laminator	LED
	LED
			Card
			Hopper
			Door
Cover	on/cancel
Release
	Button
Buttons
	on-line
	Button

D.Identifying the Parts

1.This illustration shows all of the control buttons and the LED indicator lights found on the front of the Color ID Card Printer. The laminator light indicates the current status of the printerÕs built-in laminator. When the light is flashing, the laminator is either heating up or cooling down. When the light is solid, the laminator has reached and is maintaining its target temperature.

The on/cancel button signifies that the printer power is ON and also serves to cancel the current print job and reset the printer for the next print job. This button also ejects any cards left within the printer after a print job is canceled.

The on-linebutton takes the printer on and off- line. The printer must have the on-line light illuminated in order to print. When flashing, the on-line light also serves to indicate a print error condition. Such conditions are discussed in Section 10 of this manual.

The clean/ribbon light illuminates when your ribbon supply is getting low. The light will illuminate when approximately 10-20 prints are left on the ribbon. The clean/ribbon light also serves as a reminder that the printer should be cleaned during every ribbon change (about every 250 prints) according to the steps in this manualÕs Maintenance Section.

13