C. Adjusting the

Card Separator

Flap

Adjustment to the second Internal Card Guide is now complete.

The Card Separator Flap resides inside the printer and helps prevent two cards from feeding simultaneously. This flap is adjustable to accommodate varying card thicknesses. Although the Card Separator Flap will automatically adjust to slight card thickness variations, a manual adjustment should be made in order for the printer to consistently feed single cards which vary from the standard CR-80 .030Ó card thickness. To adjust the Card Separator Flap, refer to the following steps:

1.Open the Card Hopper Door located on the right-hand side of the printerÕs exterior by grasping the top of the door and pulling straight down. Allow the door to swing completely open.

2.Remove all cards from the Card Hopper.

3.Open the top-right cover of the printer by pressing its Cover Release Button. Allow the cover to swing up and open.

4.Remove the ribbon from the printer.

5.As you are looking straight into the Card Hopper, locate the two single screws which reside in the upper corners of the back plate of the Card Hopper. You will find one screw to the right of the right Card Input Guide and one screw to the left of the left Card Input Guide. Loosen these screws.

Card Input Guides

Metal Roller

Card Input Tray

Card

Feed

Roller

Card Input

Hopper Door

49

Page 54
Image 54
FARGO electronic II manual Adjusting Card Separator Flap