52
2.If the PolyGuard chip is being placed more toward a cardÕs top edge (as shown), move the Card Guide Rail slightly toward the rear of the printer (opposite the direction you would like the chip to move).
3.If the PolyGuard chip is being placed more toward a cardÕs bottom edge (as shown), move the Card Guide Rail slightly toward the front of the printer (opposite the direction you would like the chip to move).
4.Always make very slight adjustments to the Card Sensor, and run a test print after each adjustment until the optimum chip position is found. Also, after each adjustment, retighten the screw loosened in step one.
Please refer to the following steps to adjust the
1.If the PolyGuard chips are being applied too closely to, or overlapping, a cardÕs top or bottom edge, the laminatorÕs Card Guide Rail should be adjusted. To do this, simply loosen the two screws which fasten the Card Guide Rail to the printerÕs main chassis.
Top Edge
Bottom Edge
Top Edge
Bottom Edge
4.Always make very slight adjustments to the Card Guide Rail, and run a test print after each adjustment until the optimum chip position is found. Also, be sure the Card Guide Rail always remains parallel to the card path and that the screws loosened in step one are retightened after each adjustment.
