Fostex PD204 owner manual Protector adjustment

Chapter 2: Preparation before using the PD204

Power supply priority setting (essential when using both [DC IN] and a battery)

When you use both a battery and the [DC IN] connector, you must set the power supply priority ("DC-IN" or "BATT"). For example, if you set it to "DC-IN", the battery automatically takes over only when the power supply from the "DC-IN" jack is cut off (power failure, disconnection, etc).

Note that, if you use only batteries, you do not need to make this setting.

You can make setting via the "Power priority" item in the "BATTERY SETUP" menu of the MENU mode (see page 168).

Protector adjustment

When the battery is mounted, pull out the protector to protect the battery, as shown below. While sliding the [ADJUST] levers on left and right side panels to the arrow direction, pull out the protector. There are two locked positions for the protector.

Set it to the appropriate position. Note that you should push it down when replacing the battery.

Protector

ADJUST

OUT

E

[ADJUST] levers

<Note>: The protector can protect the IDX ENDURA-7 and ENDURA-7S. When you use the ENDURA-10 or ENDURA-10S, or PowerLink is active, we recommend using the PD204 horizontally.

Location Recorder Model PD204 25