Chapter 5: Recording/Playback

Error tone output setting

During recording, if the unit encounters the following problems, the error tone is output for warning.

1.A write error happens during recording.

2.The input amplifier is clipped during recording.

3.The battery voltage drops below the specified level.

4.The remaining volume of a disk (or partition) becomes less than the specified volume.

You can make error tone output setting via the "Error tone" item in the "SYS SETUP" menu of the MENU mode (see page 160).

Mixer settings

The mixer section provides the function for mixing four analog input sources to the stereo bus. You can record the stereo bus signals to stereo L/R tracks. (When you record a digital input signal, the signal is directly recorded to the stereo L/R tracks without being routed to the mixer section.)

The four input channels of the mixer section provide controls for the analog input signal, including the filter, limiter, etc.

The following diagram shows the signal flow of the mixer section of the PD204.

Read the explanation described in the following pages and make mixer settings appropriately.

 

ANALOG IN 1-4

 

 

AUX IN L, R

 

 

 

P48V

LINE/MIC

 

 

 

 

 

 

T12V

AMP

 

 

LEVEL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SEL

 

 

 

 

GAIN

 

 

 

 

 

 

 

 

 

 

DA

 

 

 

 

LIMITER

 

 

 

 

 

 

 

HPF

 

 

 

 

 

 

 

 

 

 

 

MONITOR

DA

TO HP/MON SP

 

 

 

 

 

SEL

 

 

 

 

 

 

 

 

AD

 

 

 

 

 

 

 

PHASE

 

 

REPRO/

 

 

 

 

 

 

 

 

 

 

 

 

PFL

 

INPUT

 

 

 

 

 

 

SEL

 

DA

 

 

 

 

 

 

ANALOG OUT

 

 

 

 

 

 

 

ST BUS

 

 

 

 

 

 

 

SEND

 

 

 

 

 

 

 

PAN

 

 

 

 

 

 

 

 

 

 

FROM RECORDER

 

 

 

 

 

 

 

(REPRO DATA)

 

 

 

 

 

 

ST BUS

LIMITER

 

 

TO RECORDER

 

 

 

MASTER

 

 

(2TRK FILE)

 

 

 

 

 

 

78

Location Recorder Model PD204

Page 78
Image 78
Fostex PD204 owner manual Mixer settings, Error tone output setting