
Chapter 5: Recording/Playback
<Note>: When the system clock is set to "DIGI" or "WORD", the FS of a file to be played back must match the FS setting of the unit. Otherwise, you cannot play back the file.
In such a case, make the FS setting of the unit to match the FS of the file.
Sampling frequency and bit length selection [
]
You can select a sampling frequency and bit length combination.
Available FS/BIT options (default: 48/24)
44.1/16, 44.1/24, 48/16, 48/24, 88.2/24, 96/24, 176.4/24, 192/24
You can select a sampling frequency and bit length combination also via the "Record FS&Bit" menu item in the "SYS SETUP" menu of the MENU mode (see page 142 for details).
<Note>: The sampling frequency of the digital input signal must match the Fs/Bit setting of the PD204.
<Note>: If you change the FS/BIT setting during recording, the new setting is not valid until recording stops.
TC generator mode setting (TC recording mode) [
]
You can select the recording mode of the LTC generated by the internal TC generator or external time code.
Available TC recording mode options (default:
FREE (Free Run),
You can also select the TC recording mode via the "Gen mode" menu item in the "TC SETUP" menu of the MENU mode (see page 177).
<Note>: You can set the default LTC start time via the "Default LTC Start" menu item in the "TC SETUP" menu of the MENU mode (see page 184).
Clock pull up/pull down setting [
]
You can make the pull up/pull down setting of the sampling clock/internal TC frame rate when the clock reference is set to "INT".
Available pull up/pull down options (default: 0.0%)
+0.1%, 0.0%,
You can also make the pull up/pull down setting via the "Pull up/down" menu item in the "SYS SETUP" menu of the MENU mode (see page 143 for details).
<Note>: You cannot make pull up or down setting when the time code frame rate is set to 25 fps. If you select "+0.1%" or
76 | Location Recorder Model PD204 |