Fostex PD204 User bit setting Set Gen Ubit, 180, Jamming the time code value in Free run mode

Chapter 8: MENU mode/TC SETUP menu

• Jamming the time code value in Free run mode:

If you press the [TIME] key while the editing screen (the "Set Gen TC" screen where an editing point is flashing) is shown, the LTC start time is jammed to the internal realtime clock data.

3)Press the [EXIT] key repeatedly until you exit the MENU mode.

User bit setting [Set Gen Ubit]

You can set the time code user bit and user bit mode of the time code which is output from the [TIME CODE OUT] connector when the "Sel TC Out" item is set to "Gen".

1)When the unit is stopped, press the [SHIFT] key to light the [SHIFT] indicator, followed by the [TIME/TC SET] key.

The display now shows the TC SETUP menu screen.

2)Use the [MENU] dial to select the “Set Gen Ubit” menu item, and press the [ENTER/YES] key.

The display now shows the “Set Gen Ubit” screen on which you can set the user bit mode and the user bit value.

Shows the current user bit. You can set

the desired user bit. The rightmost two

figures of the user bit are always used re- gardless of the “Ubit

MD” setting.

Sets the user bit mode. See the table below for details about the available options. The default is “uuuuuuuu”, which is set to “00 00 00 00” by default.

Shows the user bit being output according to the current user bit mode. If you change the user bit mode.

Selecting the user bit mode

By pressing the [ENTER/YES] key while “Ubit MD: uuuuuuuu” is highlighted, the current user bit mode starts flashing and you can now select the mode (by default, “uuuuuuuu” flashes).

Flashing

180 Location Recorder Model PD204