2. WIRING
Antenna unit, front view, cover removed
6. Fabricate the signal cable |
as shown below. |
a) Remove the outer vinyl sheath, by |
about 500 mm, then armor and |
inner sheath by about 470mm. |
b) Unravel the shield to expose the |
core wires. |
c) Trim each core wire (except |
coaxial wire) considering its |
location on the terminal board. |
d) Trim the shield leaving about 500 |
mm and attach |
e) Remove insulation of each wire by |
about 6 mm. |
7. Slide a washer, and fold back armor. |
500mm
Vinyl sheath
30mm
Armor sheath | Shield |
Shield
6
Slide a washer, rubber gasket, |
washer, and clamping ring in order. |
Cut the armor around the washer so |
it is level with the washer. |
Shield
14 5 9
Conductor Fold back shield.
Coaxial cable
