Furuno FAR-2827, FAR-2127-BB, FAR-2117-BB DVI-RGB Conversion Kit for VDR connection, SLB-FRN4-A

4. INSTALLING OPTIONAL EQUIPMENT

4.3DVI-RGB Conversion Kit (for VDR connection)

This information provides the procedure necessary for the installation of the DVI-RGB conversion kit. This kit is installed in the processor unit to enable connection of a VDR (Voyage Data Recorder) or RGB monitor to record radar pictures into a VDR. When changing the D-sub 15P of the RGB cable to the BNC connector, use the BNC connector converter described on page 4-17. This RGB output complies with the image test defined in the VDR test standard, IEC 61996.

Name:	DVI-RGB conversion kit
Type:	OP03-180-2
Code no.:	008-536-070
Resolution:	Outputs RGB with the resolution of DVI input.
	Display unit	Resolution	DIP switch setting (S-1#1)
	MU-201CR	1024x1280	OFF
	MU-231CR	1024x1365	ON
Output signal specification:		Video; 0.7Vp-p, 75Ω termination, positive polarity
		Horizontal sync signal; TTL level, negative polarity
		Vertical sync signal; TTL level, negative polarity

See packing list for contents. Refer to the figure below for modification.

SQ-35 Spacer 6 pcs

Fixing holes

M3x8		DVI-RGB Conversion board
		(SLB-FRN4-A)
6 pcs					DVI video input
				DVI cable
	J9	J3
J4	(10 pin)
(6 pin)
				J615
03-2094				03P9342 board
03-2092
03-2093		RGB-BUFF board*
		(03P9229B)		D-sub 15P
M3x8
		J2		Female
4 pcs	J3
J1	(3 pin)
(13 pin)			RGB Cable
			(User supply)
Spring washer

Boss

Ferrite core

RGB video output Clamp copper tape

section by cable clamp.

To external RGB monitor or BNC connector converter

for VDR connection (see page 4-17).

Ferrite core side: Connect to DVI-D port on the upper part of the processor unit.

*Indepent of the MAIN board.

4-12