Furuno FAR-2127-BB, FAR-2827, FAR-2117-BB Wiring consideration, Standard Interconnection

2. WIRING

Wiring consideration

•To lessen the chance of picking up electrical interference, avoid where possible routing the signal cable near other onboard electrical equipment (radars, transmitting radio antennas, etc.) Also avoid running the cable in parallel with power cables. When crossing with other cable, the angle should be 90°to minimize the magnetic field coupling.

•The signal cable run between the antenna and processor units is available in lengths of 15 m (standard), 30 m and 50 m. Whatever length is used it must be unbroken; namely, no splicing allowed. Use the signal cable as short as possible to minimize attenuation of the signal.

•The radar should be connected to an emergency power source, as required by SOLAS II-1.

2.1Interconnection

Antenna unit

Monitor unit

TB801

TB802

Junction Box

RJB-001*

RW-9600
15/30/40/50 m
(Max.100 m)			m	DPYC-2.5
			5/10		Control unit
Processor unit
			5M,	(RCU-014 or RCU-015)
		Memory
			LINK
		Card
		I/F Unit	SINGLE
		CU-200-FAR
			D/D-	24 VDC or	XH10P-W-5P-A
			DVI	100-230 VAC	L=10/20/30m
Junction Box	XH10P-W-6P L=1.5/10/20/30m*				Control unit
RJB-001*					(RCU-016)
	DPYC-2.5 for AC set
	DPYC-6 for DC set
					F1

24 VDC or

100-115 VAC/220-230 VAC

F2

F3

F4

*: If the length of the antenna cable is more than 100m,

use Junction box RJB-001. However, the maximum length is 300m.

: Cable requires fabrication

Standard Interconnection

2-1