WARNING
| Do not open the equipment | |
| unless totally familiar with | |
| electrical circuits and | |
| service manual. | |
ELECTRICAL | Only qualified personnel | |
should work inside the | ||
SHOCK | ||
HAZARD | equipment. |
Construct a suitable service platform from which to install the antenna unit.
Serious injury or death can result if some- one falls from the radar antenna mast.
Turn off the power at the mains switch- board before beginning the installation.
Fire, electrical shock or serious injury can result if the power is left on or is applied while the equipment is being installed.
Be sure that the power supply is compatible with the voltage rating of the equipment.
Connection of an incorrect power supply can cause fire or damage the equipment .
Use only the specified power cable.
Fire or damage to the equipment can result if a different cable is used.
Do not install the monitor unit, processor unit or control unit where they may get wet from rain or water splash.
Water in the units can result in fire, electrical shock, or damage the equipment.
Attach securely protective earth to the ship's body.
The protective earth (grounding) is required to the AC power supply to prevent electrical shock.
CAUTION
Observe the following compass safe distances to prevent deviation of a magnetic compass:
| Standard | Steering | |
| compass | compass | |
|
|
| |
Antenna Unit | 2.15 m | 1.40 m | |
(12 kw) | |||
|
| ||
Antenna Unit | 2.05 m | 1.30 m | |
(25 kw) | |||
|
| ||
Monitor Unit | 1.55 m | 1.00 m | |
|
| ||
|
|
| |
Monitor Unit | 1.85 m | 1.20 m | |
|
| ||
|
|
| |
Processor | 1.35 m | 0.85 m | |
Unit | |||
|
| ||
|
|
| |
Control Unit | 0.30 m | 0.30 m | |
|
| ||
Control Unit | 0.95 m | 0.60 m | |
|
| ||
|
|
| |
Control Unit | 0.65 m | 0.45 m | |
|
| ||
|
|
| |
Memory Card |
|
| |
Interface Unit | 0.90 m | 0.60 m | |
|
| ||
|
|
| |
Junction Box | 1.10 m | 0.70 m | |
|
| ||
|
|
| |
Switching Hub | 1.00 m | 0.60 m | |
|
| ||
|
|
|
ii
